Announcement

Collapse
No announcement yet.

Control Hub "OFFLINE"

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Control Hub "OFFLINE"

    When my development PC disconnects from the control hub network without first issuing an ADB disconnect command, and then I reconnect to the hub and successfully issue the ADB connect command, when I compile the target device selection the control hub shows up as its IP address followed by [OFFLINE] and some other text. If I reboot the hub all works as expected. It appears that not disconnecting through ADB before disconnecting from the hub network leaves the hub in a bad state. Is this behavior expected?

  • #2
    It's probably not "expected" behavior but it happens with phones too, so it's not CH specific.

    Comment

    Working...
    X