Printig code from ROBOTC 4.*

[FTC8811]

Hi Everyone

We are wanting to print our ROBOTC source code for our notebook and we can't figure out a way to do so without it clipping off the characters past what appears to be portrait orientation. Printing in Landscape has the same problem. Any suggestions would be appreciated!

[Electonic]

well, you could just hit enter/return. Without using the ;, the IDE should just count it a one line. Anything in between {} could be done like that.
Ex:
If(joy1btn1){
you could do this instead of not returning;
you could do two lines like this
and not use the semi-colon until you are done;//not positive it it will work.

}

Other than that, you might just have to find a way to zoom out on it. Can you post your program? I might be able to load it into mine and screenshot it and crop, etc.