Technology Forum Has Moved!
The FIRST Tech Challenge Technology forum has moved to a new location! Please take a look at our forum blog for links and instructions on how to access the new forum.
Note that volunteers (except for FTA/WTA/CSA will still access their role specific forum through this site. The blog also outlines how to access the volunteer forums.
Note that volunteers (except for FTA/WTA/CSA will still access their role specific forum through this site. The blog also outlines how to access the volunteer forums.
See more
See less
-
Try different motors or swap. If the new motors do the same it's most likely a software issue, with a smaller probability that your Hub has a problem. -
GoBilda5202 Motor encoder errors
We are using GoBilda5202 series motors for drive motors and whenever we use "RUN_USING_ENCODER" mode two of the motors start to ramp up in speed quickly when setting the drive power to a low number, similar to if you set it to this mode and the drive encoders weren't conected but all the telemetry values indicate the encoders give the correct values. Any ideas on what this could be?
Leave a comment: