25 results in 0.0070 seconds.
-
FTC 965, Springfield, VA. -
We had a similar problem and wrote about it in this forum... stuck in initialization. I think its related to "I2C hanging" in earlier versions...Leave a comment:
-
Update: we put in a new hub, stripped it down to nothing, added back the servos, added back the motors, and have not yet added back the Rev color sensors...Leave a comment:
-
... I should have mentioned that the same robot was working a couple of weeks ago, and then it started deteriorating... went from hanging half the time...Leave a comment:
-
Problems Initializing
We're unable to start our robot. We can select an OpMode, then when we go to initialize, the "Robot Stopped" message goes away.... and then... -
The _mechanical_ problem with a curve turn, which is not immediately obvious, is that you are relying on differential sideways skid of your wheels on...Leave a comment:
-
*We are not using encoders
*The robot battery is always almost fully charged, around 13-14 volts.
So sometimes you are giving your...Leave a comment:
-
I started this thread, so I thought I should update to where we are...
We're doing great! After the first tournament in which the robot...Leave a comment:
-
We noticed the same thing. We found that when we unplugged and plugged back in the CDIM then it would take readings from the second range sensor. It...Leave a comment:
-
Be careful to keep the wheels on the ground while you do so. If you rotate the robot while its at an angle to the ground it will it will not be rotating...Leave a comment:
-
I'm on an older SDK, that could be the problem. I'll try to update next week.Leave a comment:
-
We've got the sensors on the same side of the robot, facing the same direction, 15 inches apart. We mount then with metal plates on the side towards...Leave a comment:
-
Two MR Range Sensors, need to restart CIM
Has anyone else had any difficulty with having two MR Range Sensors on a robot? We successfully changed the port addresses, put their addresses in the... -
I just found this also: need to unplug and plug in the CIM to get it to recognize the two range sensor addresses. If I turn off the robot, or restart...Leave a comment:
-
I can't report on our progress, because the honest truth is that the team's enthusiasm went to zero after the event at which the robot started this random...Leave a comment:
Leave a comment: