29 results in 0.0206 seconds.
-
uuhhhh...? -
From what I can see colorSensor is a NormalizedColorSensor, not an int, so you can't just check if it's equal to 0 or greater than 0. Even if it was,...Leave a comment:
-
I've known people who switched teams mid-season (when the team they were on were eliminated) but I'm not sure about simultaneously being on two teams...Leave a comment:
-
- Alaska
- California - Los Angeles
- New Hampshire
- New Jersey
- Texas - North
Leave a comment:
-
The Control Hub is only allowed to be used in certain pilot regions. Outside of that, it can only be used at Worlds by teams from those regions.Leave a comment:
-
Oh yeah, that's what it was. Duh. Thanks!Leave a comment:
-
We have the same issue, but we're using OpenCV. We had this issue last season as well, and we figured out some workaround, but I forgot what it was. The...Leave a comment:
-
If a team has already qualified for the next level, then if they would advance again, it just goes to the next team on the advancement list. So no, a...Leave a comment:
-
When our team need to do something like this in teleOp, we use a state machine.Leave a comment:
-
Do you check you battery levels when you test? Maybe your robot is too low on power to lift the arm at times.Leave a comment:
-
Can you give us more info? What is it disconnecting from, the hub or the other phone?Leave a comment:
-
If you don't want to use encoders, then using sensors like you mention is probably the best method. Touch, distance/ultrasonic, limit switches, or even...Leave a comment:
-
Try wrapping your rods with some sort of grippy material such as rubber. We are currently wrapping our claw in thin grippy surgical tubing, but anything...Leave a comment:
-
That mean that your phone isn't connected to your hub. Try changing your OTG wire between the phone and the hub, that's typically the source of the e...Leave a comment:
-
I think your second set of whiles are off. The greater thans and less thans are reversed. When it starts, the current position (0) is less than tgLeft1Count...Leave a comment:
Leave a comment: