21 results in 0.0132 seconds.
-
Thanks. I couldn't find anything about this on the forum. So, i'm going to go switch the cords. Any ideas on why it is only the motor 2 ports?... -
Hello, My team this year used the legacy module, thus allowing us to keep the original motor controllers, but I believe the ones you are looking for are...Leave a comment:
-
Help with motor wire fuses needed!
Hey guys, earlier today my team had a meeting. Long story short, motors were working, but they only worked well for about 20 seconds, then they slowed... -
ok Phil. That is exactly what I wanted to know. Sorry if I didn't make it clear.
Cheers,
ElectonicLeave a comment:
-
New power module compatibility with legacy motor controllers?
Hey guys, Me again. Anyway, I was in charge of getting the new tech to work. So, in the midst of doing that, I had to connect our Tetrix motor controller... -
Thanks! This is exactly what I had to do. Also, thanks for the link for the PDF, CraigRochester!
Cheers,
Electonic...Leave a comment:
-
FTC Driver Control Station not recognizing Logitech F130 controller! Help!
Hey guys, I am the lucky guy that gets to set-up next years tech. I was able to get the robot respond to the default program "K9Line", but... -
OH wait, I got them connected, but I can't figure out how to use the built in tank drive. Any suggestions?Leave a comment:
-
ZTE speed phone connection help
Hey everybody,
I just received the CPDM and the CLM(Core Power module and Core Legacy module). anyway, I got one of our teams ZTE speed... -
Well,"Miss Pretzel", Creo should run fine on anything above Intel 4000 graphics. Also, techinically, there is no Graphics card if it is an...Leave a comment:
-
well, you could just hit enter/return. Without using the ;, the IDE should just count it a one line. Anything in between {} could be done like that....Leave a comment:
-
nope, no error. But when i start the match on the FCS, all the robot does is lock up. Doesn't respond to the controlls at allLeave a comment:
-
Thanks, that took care of those, but now there is an error on the initializeRobot();. Is that really an error?...Leave a comment:
-
"there were errors during complilation"
That is what is says. It appears the error is on line 96. I don't understand what the error...Last edited by Electonic; 01-24-2015, 12:13 PM.Leave a comment:
-
RobotC says I have an error. I can't figure out whats wrong.
So guys, I had the program done before the robot was done. I had to wait before I could actually test it out, so here I am, a week until our competition...
Leave a comment: